02102 Plumbing Safety

12345678910111213141516171819202122
Across
  1. 1. When operating a company-owned vehicle, the person responsible for paying any fines incurred by disobeying traffic laws is the _____.
  2. 5. To protect workers and equipment in a trench, use shoring, sloping, or _____.
  3. 8. The Hazardous Materials Information System (HMIS®) is a four-color labeling system that was developed by the _____ National Paint and Coatings Association
  4. 9. Direct costs of an accident are those that are covered by _____.
  5. 10. The minimum distance between a trench wall and a spoil pile is _____.
  6. 12. When working where electrical hazards are present, wear boots or shoes that are _____.
  7. 13. To ensure that extension cords are protected from damage when run through a work site, make sure that the cords are _____colored.
  8. 14. OSHA regulations specify the use of mechanical ventilation when _________ ventilation is insufficient.
  9. 17. following a lockout/tagout procedure, the step that should be performed immediately
  10. 18. An indirect cost of a workplace accident may include _____delays.
  11. 20. When accidents happen at work, it is important to stay calm and tell your _____.
  12. 21. Work that is not done correctly, or behavior that can lead to serious injury or death, are examples of a(n) _____act.
  13. 22. after any stored energy is dissipated is to use a known power source to verify that the test ___________ is functional.
Down
  1. 2. When restoring energy to machinery or equipment after lockout/tagout, once you have replaced and reactivated all of the safety controls, you should then remove the locks and tags from the _________ switches
  2. 3. The two ______________ for confined spaces are nonpermit-required and permit required.
  3. 4. An example of a caution sign is do not_______.
  4. 5. When wearing a hard hat, it is important to maintain ______ between the hat shell and the top of your head.
  5. 6. When performing a positive fit check, you should block the exhalation valve and then _____ into the mask.
  6. 7. developed by the _____.
  7. 11. A confined space that has too much oxygen is called a(n) gassy ____.
  8. 15. To prevent injury when using a bladed tool, the blade should be _____away from you.
  9. 16. The number of contact points with a ladder that you should maintain when climbing is _____.
  10. 19. Hazardous Materials Information System (HMIS®) is a four-color labeling system that