3D Fall Final

1234567891011121314151617181920212223242526272829
Across
  1. 1. A stationary machine used for drilling precise holes, often into metal.
  2. 7. Conical tool used to size, shape, and hammer rings.
  3. 9. Hammer type used to shape metal without marring the surface.
  4. 10. A type of locking plier that clamps onto metal securely.
  5. 17. A heavy block, usually steel, on which metal is hammered and shaped.
  6. 19. The part of the torch flame that is hot and fuel-rich, appearing yellow or green.
  7. 20. Brand name for a craft knife with a very sharp, fine point blade.
  8. 21. Wooden support attached to a workbench for filing, sawing, and drilling small parts.
  9. 22. A container, often stainless steel, used to heat metal for softening.
  10. 23. Abrasive material used for cleaning or giving metal a brushed finish.
  11. 24. A clamping device attached to a workbench, used to hold materials firmly.
  12. 25. Common tool for soldering that uses a pressurized fuel source and ambient air.
  13. 26. A chemical paste applied before soldering to prevent oxidation and help solder flow.
  14. 27. Tool used to safely light a gas torch.
  15. 28. Hanging motor tool with a flexible cable used for drilling, grinding, and polishing.
  16. 29. Acid solution used to clean flux and firescale from heated metal.
Down
  1. 2. Tool used to cut intricate shapes out of sheet metal.
  2. 3. Tool used to flare the end of a metal pin to permanently join two pieces.
  3. 4. Common brown buffing compound used as a pre-polish before the final rouge.
  4. 5. Small, narrow files used for detailed shaping in tight spaces.
  5. 6. Metal alloy with a low melting point used to join two pieces permanently.
  6. 8. Tool with adjustable clips used to hold components in place for soldering.
  7. 11. The measurement of wire or sheet metal thickness.
  8. 12. Red polishing compound used for a final, high-shine finish.
  9. 13. Hammer with one round, spherical face, used for texturing or riveting.
  10. 14. Tool used to safely move hot metal pieces in and out of the pickle.
  11. 15. Small magnifying lens used to closely inspect gemstones or small work.
  12. 16. Position a ring must be in where the ends are flush, no light can be seen, and the ring is ready to be soldered.
  13. 18. Pliers with conical jaws used to create loops in wire.
  14. 27. A thin, sharp metal rod used to guide and push solder while heating.