ART 2025 - Puzzle 2

3. When utilizing any tool or equipment with an electrical chord, a _____ inspection must be made
6. If the hoppers are down and _________ you should go on hopper wait
8. Shifting transmission at higher RPM's causes damage and is considered _____?
13. Highwall conditions throughout the mine need to be inspected at least _____ and after any changing condition like freeze/thaw?
14. Explosive magazines shall be _____ when unattended
16. Who can shut down a run due to conditions?
17. The accronym used when remembering how to best use a fire extinguisher?
18. For lights to be considered downable it must be consdidered a ______?
20. A fire extinguisher on a piece of equipment should be inspected each _____ it is operated
21. You should never connect or disconnect an power cable when it is ______?
23. What is the minimum following distance at 10 mph
25. Need to be filled out at beginning of every shift before operating equipment
26. What must be worn in ALL small vehicles and Equipment
28. What type of vehicle should always yield the Right-of-way?

1. Always turning to the drivers side is best practice of what
2. A hazard that can cause permanent hearing loss if exposed to high levels for extended periods of time
4. What is the turning speed on the dump before dumping
5. What is the minimum distance between two trucks dumping on the dump
7. Must be stored in flammable cabinet
9. what is the horn signal to move out or back up
10. This is everyone's responsibility
11. an engineering control to keep equipment on the roadway?
12. A space the requires a permit to enter due to limited access or other physical hazards?
15. What must be on every small vehicle before entering the active pit?
19. Important training records needed for promotion
22. The following are considered ______ backup alarm, brake, fuel leak, horn, fire suppression, seatbelt etc.
24. What is not permitted on our mine radio
27. This is not allowed in any equipment or office building