Auto III electrical basics

1234567891011121314151617181920212223
Across
  1. 2. Which setting on a DMM (digital multimeter) would be used to measure current flow?
  2. 7. A ________ _______ when used will save your keep alive memory when you disconnect the batt.(2 words)
  3. 8. If a bare power wire touches metal it will blow the fuse. This is called a _______ ___ ________ (3 words)
  4. 10. When you replace a key or switch, you will most likely need to do a security system ___________.
  5. 12. A fully charged 12-volt flooded-cell automotive battery should have an open-circuit voltage of?
  6. 15. If the horn relay is stuck ______, the horn will blow continually.
  7. 16. A vehicle with a fully charged battery does not make a "click" sound or crank the engine when the ignition key is turned to the START position. It may have a faulty ________ ______ switch. (2 words)
  8. 17. When the airbag fuse is removed the SRS light should __________.
  9. 18. If the battery drains over night, then it may have a ________ draw.
  10. 21. While checking for voltage drop in a charging system when the charging system is operating, a technician finds 1.1 volts being dropped between the alternator output and the battery post on the 12-volt positive side. Which is the most likely explanation? ______ _________ at the alternator output terminal.
  11. 23. What tool can test volt, amp, and ohms?
Down
  1. 1. When load testing an alternator, do not exceed the alternator ______ _________ (2 words)
  2. 3. Which tool would the technician most likely use to bypass the circuit?
  3. 4. When measuring current flow, the power must be on and the meter connected in ______ with the circuit.
  4. 5. Over tighting a belt could break off an alt. ______ ____. (2 words)
  5. 6. If one bulb is dimmer in a parallel circuit, it could be a _____ __________ (2 words)
  6. 9. Water leakage into a taillight housing can cause excessive_______________.
  7. 11. Before a starter is removed from an engine, it is important to disconnect the __________ lead from the battery.
  8. 13. A shorted ________ can excessive starter current draw.
  9. 14. What color is the wire to the airbags?
  10. 19. A battery load test is being performed. The proper method is to apply _____ of the CCA:
  11. 20. During a charging system voltage drop test, the alternator is producing 14.3 volts at the alternator but only 13 volts are present at the battery. It is most likely a __________ battery cable.
  12. 22. Fog lights fail to operate when the high beams are on but work with thelow beams. This is _________ operation.