Construction Technology Final Assessment 1

123456789101112131415161718192021222324252627282930313233343536373839
Across
  1. 2. You have to do this to the ends of long boards so they don’t fall when cutting on a saw
  2. 4. Always feed material being sanded against this, which describes the motion of the tool
  3. 5. You should do this to hand-held tools when changing belts, bits or blades
  4. 9. This machine makes angled cuts easier as it can be rotated from 0 - 60 degrees
  5. 10. Though they can protect your hands, these can get caught on tools and equipment
  6. 12. What must you use if the stock you are jointing is lower than the fence?
  7. 14. If you cut once, how many times should you measure - as per the old saying
  8. 15. The planer reduces what dimension of a board?
  9. 18. No matter what machine you are operating, wearing these is always necessary
  10. 21. This substance is created when wood is machined; it is also hazardous to your health
  11. 22. Never make free-hand cuts on the table saw, always use this device
  12. 24. The machine used to create smooth, flat surfaces on faces and edges
  13. 25. Before cutting a sharp curve or corner you should make what kind of cuts?
  14. 27. A mitresaw is only used for this type of cutting operation
  15. 28. This term refers to turning power on tools and machines
  16. 30. On large machines use one of these foot-operated devices to stop the machine’s motion
  17. 32. A powerful cutting machine with a blade mounted on a sliding horizontal arm
  18. 33. What side of a piece of wood should never be jointed?
  19. 35. This should be removed with a scraper before using the planer?
  20. 37. Because of the waste created, what must always be on when using the planer?
  21. 39. If a blade breaks on the bandsaw what should you do?
Down
  1. 1. To prevent uneven wear on sanding belts move wood in this manner, like dancing
  2. 3. These bits take the sharp edge off a piece of wood, making it smooth and rounded
  3. 6. A twist-lock power switch requires the user to do this to the shut off switch before using it
  4. 7. When this machine is turned on, two separate sanding surfaces start moving
  5. 8. Make several of these when removing a lot of material or when cutting harder stock
  6. 11. This tool oscillates, which means to move up and down continuously
  7. 13. On the table saw, the wheel on the front controls the blade’s what?
  8. 14. This is pressure-sensitive on most drill/drivers
  9. 16. Our mitresaw has the ability to do this, which allows it to cut larger widths of material
  10. 17. This power source slides and locks onto the bottom of many hand tools.
  11. 18. What is the minimum length of material for our planer?
  12. 19. How high above the material should the upper guide on the bandsaw be set?
  13. 20. A router can be used free-hand or mounted in one of these
  14. 23. Like other tools, routers are used with these cutting pieces, which are interchangeable
  15. 26. A continuous loop of metal teeth is the most visible moving part of this machine.
  16. 29. What is the maximum depth of cut on the jointer?
  17. 31. A sanding belt that is loose or this, is dangerous and should not be used
  18. 34. A regular blade was installed in one of our table saws, what blade was in the other?
  19. 36. How can you tell if you are twisting a blade or applying too much pressure on a cut?
  20. 37. The jointed side of a board should face what direction when using the planer?
  21. 38. What needs to be tightened on a drill to secure the bit?