cppde by Rishabh Rawal

1234567891011121314151617181920
Across
  1. 3. Which of the following is the best tube material from thermal conductivity point of view alone?
  2. 4. The distance between the centers of a rivet hole to the nearest edge of the plate is called
  3. 7. At equal mass velocities, the values of film co-efficient for gases as compared to that for liquids are generally_____
  4. 10. Normal screwed fittings are used for pipes upto a diameter of _________ inches.
  5. 12. an _________ is used for changing the direction of a pipeline.
  6. 13. Safety valves are provided in chemical equipments to guard against excessive____
  7. 16. _________ support is meant for supporting small vessels
  8. 18. Shortest distance between two tubes is called tube_____.
  9. 19. Vertical storage vessels are never supported by __________ support.
  10. 20. ___pipe heat exchanger is also known as 'hair pin type' exchanger
Down
  1. 1. The ratio of lateral strain to linear strain is termed as the
  2. 2. Removable connection of tubes to tube sheet is called
  3. 5. ________ tower is the most suitable gas-liquid contacting device involving highly corrosive fluids.
  4. 6. . Maximum plate efficiency is achieved in case of _________ flow.
  5. 8. Value of Peclet number = ∞, is the representative of------- flow.
  6. 9. __________ closure is the weakest enclosure for cylindrical vessels
  7. 11. The ratio of linear stress to linear strain is termed as the modulus of ____.
  8. 14. The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the _________ stress.
  9. 15. Thin spherical shells subjected to internal pressure, develop _________ stresses.
  10. 17. In a _________ riveted joint, the number of rivets decreases from the innermost row to the outermost row.