Engineering
Across
- 6. low wall around the edge of a roof
- 7. Legal right to pass without obstruction
- 8. Equal to 0.3048 meter
- 9. 1/1000"
- 10. unit of electrical resistance
- 13. Maximum ability to contain or hold something
- 18. Place where two elements meet
- 19. Thin spacer
- 20. Allows fluid flow in one direction and closes to prevent passage in the opposite direction
- 23. Weight on a structure consisting of movable objects or persons
- 24. Device for keeping liquids in motion
- 25. 43,560 square feet
- 27. Separate surfaces on the same level
- 29. Any surface which has been cut or built up to an indicated elevation
- 31. Structural element used to resist lateral loads
- 32. bars used to increase tensile strength of concrete
- 33. Side piece or post of an opening
- 34. Pulling or stretching stress
- 37. Common designation for spacing of elements
Down
- 1. Angle of tilt
- 2. common wallboard
- 3. Flat piece of steel
- 4. weight of structural part of a building
- 5. A slot cut in a shaft
- 8. Concrete under columns
- 11. Influence on a body which causes it to accelerate
- 12. A beam that extends beyond its support
- 14. Coating of metal with another by an electrolytic process
- 15. I
- 16. Top of a roof where two slopes meet
- 17. Engineering pertaining to aircraft and space travel
- 21. Building framing in which studs are one piece from foundation to roof
- 22. Causes the most headaches in the construction industry
- 25. Ground plan that shows horizontal direction of a road
- 26. Two forces, opposite in direction along parallel lines
- 28. Flow of liquids from any other than its intended source
- 30. Quantity of matter a body contains
- 35. fastener
- 36. Standard thread with angle of 29 degrees