IPC Crossword Puzzle #3

12345678910111213141516171819
Across
  1. 1. Measurements will be made using either the International System of _______(SI) or Imperial English equivalent units followed in [brackets].
  2. 3. The inspector shall not [D1D2D3] select the Product ________ for the assembly under inspection.
  3. 5. How many strands can be damaged for a class 3 wire with 32 strands that will not be tinned?
  4. 7. In case of a discrepancy, the ________ criteria always take precedence over the illustrations.
  5. 11. A "__________ loop" is a loop or wire bend formed to direct condensation or accumulated moisture to a noncritical area.
  6. 13. Conditions that are not specified are considered acceptable unless it can be established that the condition affects _____, fit, function or reliability.
  7. 14. "N3" means "______ requirements established for Class 3."
  8. 16. Heating processes used to shrink sleeve insulation shall not [D1D2D3] ________ the connector, wire, sleeving, or adjacent components.
  9. 17. Chemical insulation stripping agents shall [D1D2D3] be used only for _____ wires.
  10. 18. All instructors, operators, and inspection personnel shall [D1D2D3] be proficient in the _______ to be performed.
Down
  1. 2. The length of lay for each _______ is 8 to 16 times the outer diameter of the bundle.
  2. 3. Conductor strands shall not[N1D2D3] be ____ or modified in any manner to reduce CMA to fit a termination.
  3. 4. Stranded wires shall not [D1D2D3] be tinned when wires will be used in ________ terminations
  4. 6. The tolerance for magnification ________ is +/-15%.
  5. 8. How many strands can be damaged for a Class 3, 22 strand wire that is to be tinned?
  6. 9. Solder connections produced using "____-clean" processes need only be cleaned when required.
  7. 10. A Stamped and Formed - Open Barrel - Insulation Support - Crimp tab must encircle the wire insulation, leaving an opening of _______ degrees or less.
  8. 12. The primary goal of ________ control is to continually reduce variation in the processes, products, or services.
  9. 15. With an outer mold fill, mismatch _________ lines measuring 0.75mm or less
  10. 19. What is the maximum allowable strands scraped, nicked or severed for a Class 2 wire with 66 strands?