Level 2 Module 2

1234567891011
Across
  1. 2. Article 210 provides the general requirements for _____ _____ not over 1,000V ac, 1,500V dc, nominal.
  2. 4. For dwelling units, the calculated floor area for the general lighting load shall not include ______ _____.
  3. 5. No conductor shall be used where its ______ temperature exceeds that designed for the type of insulated conductor involved.
  4. 6. Circuit breaker enclosures shall be permitted to be installed _____ where the circuit breaker is installed in accordance with 240.81
  5. 9. True or False: the surge-protective device (SPD) required for a dwelling unit shall be an integral part of the service equipment or be located immediately adjacent thereto.
  6. 10. Article 220 provides requirements for calculating branch-circuit, ______, & service loads.
  7. 11. In accordance with Article 225- Outside Branch Circuits and Feeders, a building or structure shall be supplied by a maximum of ___ feeder(s) or branch circuit(s), unless specifically permitted otherwise.
Down
  1. 1. In accordance with Article 225 - Outside branch circuits and Feeders, the disconnecting means for a building supplied by a feeder shall be installed at a(an)_____ location.
  2. 3. Circuit breakers shall ____ all ungrounded conductors of the circuit both manually and automatically unless specifically permitted otherwise.
  3. 7. Conductors for branch circuits (Article 210) are sized to prevent a voltage drop exceeding ___ percent at the farthest outlet of power, heating, and lighting loads, or combinations of such loads.
  4. 8. Article 215 provides the installation, overcurrent protection, and conductor sizing requirements for _____ not over 1,000V ac, 1,500V dc, nominal.