Lift Cell

3. Caused by a lifelong lack of calcium
4. The Inbound lift mast has a reference switch near the ________ to provide an operational limit.
7. One of the different positions that a lift can be moved to.
9. An Inbound LHD has how many sensors.
10. We use the up and down arrows we can drive this piece of equipment.
13. If a lift is has an Idle status, then the lift (is) _______ .
14. The status the lift has to be in to run.
15. Name a piece of Hardware does Icinga monitors.
17. This measures the position of the lift along the mast.
18. The bot induction card allows you to __ Bots.
20. One of the 3 status's that the P&D can be in.
21. The _______ must all be cleared to perform a P&D Hard Reset.

1. If a lift is in production to switch it to Maintenance and retract the LHD, press Stop, Maintenance, _______, Retract.
2. The position you select if you don't want the lift to move.
5. The Mode that allows the Cell Operator to control the P&D.
6. The Hard Reset button is only available in the following operational state.
8. The page on the HMI that is used to move lifts to the maintenance position.
11. The Bay Manager allows you to __
12. The result of a Hard Rest on the Outbound P&D.
16. If you at the adaptor cell, which P&D position is closest to you.
19. When you should change the speed profile on a Cell.