Machines and safety

1234567891011121314151617181920212223242526272829303132333435363738
Across
  1. 3. A power tool used to cut decorative edges or grooves.
  2. 6. A sander where you must only sand on the downward-moving side.
  3. 8. The direction of the fibers in a piece of wood.
  4. 13. A machine that spins wood to create bowls or table legs.
  5. 14. A tool used for very precise measurements of thickness.
  6. 16. A wooden peg used to reinforce a joint.
  7. 17. A machine used to make the edge of a board perfectly straight.
  8. 20. Wood made of thin layers glued together.
  9. 23. A wooden or rubber hammer used to strike a chisel.
  10. 24. A tool used to check if a corner is exactly 90 degrees.
  11. 25. A clear finwo pieceish applied to protect the wood.
  12. 26. Always remove the ______ from the chuck after tightening a bit.
  13. 28. Use a ______ stick to keep fingers away from moving blades.
  14. 30. Use a ______ gage when cross-cutting a board on the band saw.
  15. 32. A heavy tool on a workbench used to hold a project still.
  16. 34. The part of the drill press that holds the bit.
  17. 35. A sharp metal tool used for carving or paring wood.
  18. 37. The oscillating ______ sander is used for interior arcs.
  19. 38. A very coarse file used for rough shaping of wood.
Down
  1. 1. The tiny particles of wood created by cutting or sanding.
  2. 2. A hand tool used to shave thin layers off a board.
  3. 4. The most common type of bit used for small holes.
  4. 5. A hard, dark circle where a branch once grew.
  5. 7. These glasses must be worn at all times in the shop.
  6. 9. A scratch ______ is used to pre-mark a hole for drilling.
  7. 10. A flat bit used to drill large through-holes.
  8. 11. The number that indicates how coarse or fine sandpaper is.
  9. 12. A sanding device that uses a continuous loop of sandpaper.
  10. 15. Band saw teeth must always point in this direction.
  11. 18. Cuts made to prevent the band saw blade from binding on curves.
  12. 19. A bit used to drill flat-bottom holes.
  13. 21. Used on the band saw for ripping or resawing a board.
  14. 22. Used to secure a work piece to the drill press table.
  15. 27. When the wood is thrown back at the operator.
  16. 29. Used to change the color of the wood.
  17. 31. On a band saw, use this only in emergencies.
  18. 33. A tool used to see if a surface is perfectly horizontal.
  19. 36. The general name for the cutting tool used in a drill.