SAFETY CROSSWORDS

123456789101112131415161718192021222324252627282930
Across
  1. 1. ______ can be checked by inflating to see if it holds pressure or emits bubbles under water.
  2. 5. Mechanical lifting devices include ______, hoists, slings, jacks and forklifts.
  3. 6. Organizational ________ for swift mission accomplishment often triggers individuals to cut corners.
  4. 9. ___ atonia is a state in which the motor neurons are not stimulated and thus the body’s muscles do not move.
  5. 11. Safety was created to _______ mishaps.
  6. 12. Aircraft shall not be taxied closer than 100 feet to an active ________ where aircraft are operated unless taxiing on an established taxiway.
  7. 16. A Job Safety Analysis (JSA) is required for any ________ or process not driven by existing guidance that adequately covers all safety requirements.
  8. 18. Unattended-____-ing fires are the most common fires on the installation.
  9. 19. An inadequate presence of _____ often lead to the concealment of hazards and an unsafe workplace.
  10. 21. The leading cause of mishaps in the squadron is ________ or complacency.
  11. 24. Adjusting the position of office equipment for good body posture will minimize ______ on muscles.
  12. 25. ______ are considered jewelry and will not be worn on the flightline.
  13. 27. _____ result from operating in the winter environment without the use of PPE.
  14. 28. A good way to gauge your organizational safety program’s culture is to find someone in violation of a safety requirement and see how many people ____ out the corrective action.
  15. 29. The ____ establishes guidance and is the authority on fire, electrical, and building safety.
  16. 30. Work surfaces can be adversely affected by high ____ conditions.
Down
  1. 2. Falls are primarily associated with portable _______.
  2. 3. A Safety ________ is a worker trained in CPR and qualified to operate the equipment in use. Responsible for placing equipment in a safe/neutral mode and administer immediate assistance to a technician in the event of an emergency.
  3. 4. The AF Form 980 (Caution Tag) shall be used to warn other against potential hazards, caution against unsafe practices and to prescribe precautions to protect personnel and ________.
  4. 7. __________ are key to the safety program because they are responsible for maintaining a safe and healthful workplace.
  5. 8. PPE is only an effective hazard control if it is _____.
  6. 10. Use spotters when backing and visibility is limited or impaired, especially in ______ or confined spaces.
  7. 13. The ___ is an agency which was created for the purpose of protecting human health and environment by writing and enforcing regulations based on laws passed by congress.
  8. 14. _______ may cause worker inattention and inability to concentrate on job tasks that could result in trips, falls, inability to carry heavy articles properly and exposure to vehicles and other moving objects the worker may fail to observe.
  9. 15. Engineering ________ are the preferred method of reducing exposure hazards, but are not always feasible.
  10. 17. One of the 3 components you're tested on during your PT Test? ___.
  11. 20. ______ is the acronym for Hazardous material.
  12. 22. It is not uncommon for personnel to look both ways before _____ a highway.
  13. 23. Color coded ______ is often used to highlight hazards.
  14. 26. Flying particles like caustic liquids, sawdust, debris, silt and sand pose serious dangers to the _____.