Sander Safety

5. Work must be done on the side of the disc rotating ____________.
6. Make sure ____________ is holding the abrasive disc tightly to the revolving plate.
8. Do not leave the machine until it has come to a complete ____________.
10. Remove ____________ , eliminate loose clothing and confine long hair.
12. Material should be held flat against the table and hands should be kept clear of the ____________ disc.
15. The belt must be ____________ if any changes or adjustments are made.
16. Make sure there is adequate ____________ on the belt and that it is not torn.

1. Make sure all ____________ are in place and operating correctly.
2. Make all adjustments except final belt tracking with the ____________ off.
3. The table should be adjusted to within ____________ sixteenth of an inch from the abrasive belt.
4. Keep ____________ clear of the abrasive belt while operating and keep material flat on the table. Sanding can be done on either side of the table / belt.
7. Always use proper____________ protection.
9. The abrasive disc should not be ____________ or damaged.
11. When changing the belt make sure the ____________ runs as arrows indicate.
13. The ____________ should be adjusted to within 1/16” of the abrasive disc.
14. Operate only with instructor’s ____________ and after you have received instruction.