Section Views And MDET Review

123456789101112131415161718
Across
  1. 3. Cuts through only a portion of the part, a "3/4 view"
  2. 5. What type of projection does the USA use
  3. 7. Note type that applies to only one specific area of a drawing
  4. 9. The front view shows Width and _____ of a part.
  5. 10. Note type that applies to the whole drawing
  6. 13. Lines angled at 45* that tell us where a part has been cut through
  7. 16. What do orthographic views describe
  8. 17. There are this many parts of a cutting plane line
  9. 18. A section that cuts through the whole part
Down
  1. 1. Line type that is made up of a view identifier, a phantom line, and a direction indicator
  2. 2. What is identified on the second line of the view label
  3. 4. The ______ attached to the end of the cutting plane line indicates the direction of sight.
  4. 6. what size paper is a sheer 11" x 8.5"
  5. 8. A Permissible variation of a dimension
  6. 11. this imaginary thing indicates the location of an imaginary cut made through an object
  7. 12. Dimensioning style where dimensions originate from one common datum
  8. 14. A view that cuts a part to show something that otherwise would not be fully described without dimensioning a hidden line
  9. 15. Line 1 Long Dash followed by 2 short dashes followed by 1 long dash