Surface and Mine Issues

123456789101112131415161718192021222324
Across
  1. 2. When utilizing any tool or equipment with an electrical chord, a ______ inspection must be made.
  2. 5. What is not allowed in the mine and only in designated areas on the surface?
  3. 7. Compressed gas cylinder should always be in what position?
  4. 8. The area of an serious accident, which may result in the investigation by MSHA or company personnel will be _____ and the site will not be disturbed.
  5. 9. Reporting-Immediately report all injuries, illnesses, and property _______.
  6. 12. This is everyone's responsibility!
  7. 17. Never make a process, equipment, or procedural change without the required _______.
  8. 20. During transportation, detonators shall be _____ from explosives or blasting agents.
  9. 21. Explosive magazines shall be _________ when unattended.
  10. 23. What must all individuals wear when on top of trucks, barges, working over six feet with a risk of falling, and on a bench top within 6 ft of the edge or past the last line of drilled holes?
Down
  1. 1. What can never be used to repair an extension cord?
  2. 3. What is the purpose of roof bolting?
  3. 4. A fire extinguisher on a piece of equipment should be checked each ______ it is used.
  4. 6. Cap lamps must be carried and illuminated by all persons underground except when in an office building.
  5. 9. What must be done with a damaged tow strap or an electrical chord with a missing ground prong?
  6. 10. What is the main hazard associated with methane?
  7. 11. You should never connect or disconnect an electric power cable when under a _____.
  8. 13. All hazards such as manholes, trenches, excavations, or drop-off shall be properly __________.
  9. 14. What type of permits will be obtained and procedures strictly followed, where required?
  10. 15. What kind of hazard does laying a chord on the floor without being taped or properly covered create?
  11. 16. What are faces and muck piles examined for after each blasting operation?
  12. 18. What type of vehicle should always yield the right-of-way?
  13. 19. Where hazards exist, gloves and loose fitting clothing will not be worn while working around rotating ______ of machinery.
  14. 22. Is methane found high near the roof or low near the floor?
  15. 24. Always stand to the _____ of electrical switches when energizing or de-energizing