Tool Safety Crossword

123456789101112131415161718192021222324252627
Across
  1. 2. what stroke to sand on disk sander
  2. 4. long end of work should be placed on this side of drill press
  3. 5. never look _________ the planer while it is running
  4. 8. minimum length in inches for jointer/planer
  5. 9. should be clear before using the router
  6. 10. avoid jointing edges that contain these
  7. 11. how the hand router should be held
  8. 15. what should you do with router when finished (wait, ____ _____, pointed away)
  9. 16. chuck key should be __________ from chuck and table before drilling
  10. 19. cut to prevent bending or breaking of band saw blade
  11. 21. never apply direct _________ over jointer blades
  12. 23. never use this and the fence together on table saw
  13. 24. use clamp on drill press if this size or smaller
  14. 25. do this frequently on drill press to insure bit can cut properly
  15. 27. always keep these 4 inches from blades/bits/abrasives
Down
  1. 1. amount that should be removed on planer
  2. 3. number of pieces should be cut on miter/up cut saw at a time
  3. 5. never let someone stand to the right or end of this when using jointer
  4. 6. where to stand when using table saw
  5. 7. direction boards should be run in planer
  6. 12. _____% of the time look at the fence and 25% of time look at blade when cutting on table saw
  7. 13. what throat size to use on spindle sander
  8. 14. always make sure boards are tight against this when cutting on miter/up cut
  9. 17. used when cutting or drilling round stock
  10. 18. where should you stand when using the planer
  11. 20. direction should you sand with edge/spindle sander and router
  12. 22. never ____ board back through on table saw, always push
  13. 26. should be placed 1/4" above material on band saw/scroll saw