Warrior Woodworking - Final Review

12345678910111213141516171819202122232425262728293031323334353637
Across
  1. 3. What lumber is Purple in color?
  2. 6. always put _________ before gluing or finishing.
  3. 8. What color is the exotic wood "Padauk" you could have used for your inlay?
  4. 11. Clamping your project before putting glue on is called _____-clamping.
  5. 12. The purpose of a stain is to change the _______ of your wood.
  6. 13. What machine puts a decorative edge on your projects?
  7. 14. The 3 primary concerns in woodworking are: Exposure, Limitations, and ___________.
  8. 18. What kind of cut goes across the width of the board changing its length?
  9. 22. Maple is the ________ in color of our wood choices for our projects.
  10. 24. The "convex" surface that curves out when created in woodturning is called a ________.
  11. 26. The best machine to cut curves is called a ________.
  12. 28. What is the "concave" cut that you make while cutting curves in woodturning called?
  13. 30. Use this instead of your thumbs to push your board through the saw blades.
  14. 31. We used ______ polish to finish our woodturning projects.
  15. 34. The term used to describe the "sides" of a board is called the ________.
  16. 36. What grit sandpaper is the coarse(roughest)?
  17. 37. The term used to describe the ends of a board is called the ____________.
Down
  1. 1. What's the name of your Woods teacher?
  2. 2. Always sand _______ the grain of the wood.
  3. 4. Always _______ all lock knobs before adjusting any machine.
  4. 5. The term used to describe the flat top & bottom of a board is called the _________.
  5. 7. We are the Arapahoe ________?
  6. 9. The circular lines on the end of a board are called ________ rings.
  7. 10. 80 Grit sandpaper leaves the most visible ______.
  8. 11. A _______ is a channel cut across a board.
  9. 15. Gluing the edges of a board together is called edge-___________.
  10. 16. What's the name of the machine we used for woodturning?
  11. 17. 220 grit sandpaper is considered _______ grit sandpaper.
  12. 19. A channel cut on the end of a board is called a _______.
  13. 20. What machine did you use to crosscut most of your parts.
  14. 21. What is the best machine for "Ripping" cuts?
  15. 23. What is it called when a board is thrown out of a machine?
  16. 25. On the Disc Sander, always use the _______ side.
  17. 27. A "countersink" and a "______" hole is drilled for screws.
  18. 29. Lumber that is imported is called ________ lumber.
  19. 30. The purpose of a finish is to _______ the wood.
  20. 32. What is the cut called where you cut along the grain changing a boards width?
  21. 33. Always ________ up your own mess.
  22. 35. You may edge join & face join a board but you should never ______ join a board on the jointer.