Woodshop Safety

2. What is the number one priority in the shop?
5. Sander What machine is the best choice for removing small amounts of material from the face of a board?
7. What is the minimum material length when ripping on the table saw?
9. The edge of your board must be tight against the _____ when performing crosscutting operations on the miter saw.
10. Always use a ______ when crosscutting more than one board to the same length.
12. Which machine would be the choice to flatten, straighten and square the edge of a board.
15. Saw You should always use push pads when creating dadoes or rabbets on a _____ ___ .
16. What machine is the best choice for removing large amounts of material from the face of a board?
19. Jointed Edge Always place the ______ ______ ______ of your board against the fence when ripping on the table saw.

1. When ripping on the table saw, if the fence is set to _______ inches or closer to the fence, you must use a puch stick.
3. Saw Which machine is the best choice to rip material to final exact width?
4. Inch How far above your material should the foot of the bandsaw be set?
6. Saw Which machine is the best choice to crosscut material to final length?
8. What is the process of joining two or more boards together to create a longer or thicker board?
11. Saw What machine is the best choice to rough cut sheet goods or rough lumber?
13. How many cuts does it take to cut a board to length on the miter saw?
14. the table saw
17. Grain You should never joint the _____ _____ of a board.
18. Height Name one thing that must be checked prior to using the table saw.