2D drawing and assemble

Edit Answers
123456789101112131415161718192021
Across
  1. 2. view- creates a view of the referenced design.
  2. 4. has two degrees of rotational freedom, pitch and yaw.
  3. 5. group- If you move or apply a joint to one of the components, all of them move together in the canvas.
  4. 8. view- Creates a full, half, offset, or aligned section view through the design.
  5. 10. provides two degrees of freedom, translational and rotational.
  6. 13. built joint- positions components relative to one another
  7. 14. component- creates new internal or external component in the assembly.
  8. 18. reports interference between selected solid bodies or components.
  9. 19. has a single translational degree of freedom.
  10. 21. Allows three degrees of freedom allowing two components to rotate while sliding across a plane.
Down
  1. 1. created between two straight edges.
  2. 3. fixes two components to one another.
  3. 6. reports distance, angle, area, or position data of the selected object.
  4. 7. position components relative to each other in an assembly, then defines the relative motion between them.
  5. 9. of joints- You can create joints with both the Joint and As-Built Joint commands.
  6. 11. mark- select a rounded edge, such as a fillet, hole, sphere, or cylinder.
  7. 12. view- creates projected orthogonal and isometric views of the design.
  8. 15. mark pattern- center mark pattern including a PCD is created.
  9. 16. Slot- allows two degrees of freedom but components can rotate around different axes.
  10. 17. view- creates a circular detail view of a portion of the design.
  11. 20. constrains the motion of two bodies to pure rotation along common axis.