Across
- 2. Method of slotting interlocking wooden pieces together without glue or screws
- 3. Computer-controlled cutting machine used to manufacture full-sized wooden furniture
- 4. Acronym for Computer Aided Design software like Onshape
- 6. Strong engineered timber made of glued layers selected for the main stool project
- 15. The bonus wooden project designed in Onshape for students who finished early
- 16. The study and measurement of human body dimensions to guide product sizing
- 17. tool used in Onshape to convert a 2D sketch into a 3D solid model
- 18. The standard unit of measurement used in Onshape and workshop designs
- 19. The cloud-based 3D CAD modeling software used in class
- 21. The science of making products fit the user comfortably and safely
- 24. The vector file format exported from Onshape and sent to the laser cutter
- 25. A recessed slot or hole designed to receive a corresponding joint piece
- 26. Smooth 3mm manufactured wood board used for final laser-cut scale models
- 27. The project rulebook outlining goals, target user, location, and constraints
- 28. Measurement from the floor to the crease behind the knee determining stool height
- 30. Arranging flat parts on material sheets to minimize waste
Down
- 1. Cheap manufactured board made from glued wood chips compared in material research
- 5. Type of upright posture sitting supported by stools during work
- 7. The leftover scraps of sheet material after all parts have been cut out
- 8. Type of ergonomics focused on making flat-pack assembly clear and intuitive
- 9. The process of putting flat-pack parts together to form the complete product
- 10. The two pelvic contact points measured to determine minimum seat width
- 11. An early physical model built to test and improve a design idea
- 12. High-precision machine used to cut out cardboard and 3mm MDF parts
- 13. Natural timber cut directly from trees compared against manufactured sheet boards
- 14. The 1:5 proportional ratio used for prototyping the stool before full production
- 20. The initial 2D outline created in Onshape before converting it to 3D
- 22. The concept of finding a stool height that is not too high or low but just right
- 23. Material used to build initial 1:5 scale test models in class
- 29. Body part measured from bottom to knee to calculate seat depth using the sixty percent rule