Auto II Electrical

Edit Answers
1234567891011121314151617
Across
  1. 2. What protects the door panels from moisture?
  2. 5. Wire strippers should remove the _______ and not damage the wire strands.
  3. 9. Before removing your starter, you should remove the _______ battery cable.
  4. 12. The ignition voltage to the starter relay must pass through a clutch switch or a ____ _____ switch (3 words)
  5. 14. When testing the starter current draw, you should use an ammeter and crank the starter no more than ? seconds.
  6. 16. Excessive _______ in the pos circuit can cause slow cranking speed and low current draw.
Down
  1. 1. You should apply solder to the ____ _____. (2 words)
  2. 3. What type of solder should be use when repairing a wire?
  3. 4. When doing a voltage drop test on the starter ground circuit, you connect on tester on the negative battery post and to the? (2 words)
  4. 6. What is considered a permanent wire repair?
  5. 7. Pressing the horn button send a ground signal to the horn _____?
  6. 8. Troubleshooting cars with multiple computers, you should use?
  7. 10. Most modern cars have _______ horn(s).
  8. 11. What part of the starter engages the flywheel? (2 words)
  9. 13. When diagnosing a electrical problem, you should check the _________ first.
  10. 15. Coating the soldering gun tips with solder before using is called?
  11. 17. You can prevent the car from starting, you can disable the ignition, fuel pump, or by? (3 words)