Across
- 3. pulls a line to the specified point like a magnet
- 4. relocates a line/drawing
- 5. creates a reflection
- 8. locks the crosshair to only vertical and horizontal lines
- 11. command that repeats the next command until canceled
- 13. object with a diameter as a measurement indicator
- 18. measurement of an object- length, radius/diameter, or angle
- 20. numerical value used to measure 1/2 the distance from the middle of the circle to its edge
Down
- 1. allows change in size (up or down) of the drawing
- 2. allows you to zoom to a selected area of the drawing space
- 6. creates parallel lines at a set distance
- 7. allows you to see everything in drawing space at once
- 9. adds information/labels to a drawing
- 10. connects to point to point
- 12. where commands are located on the user interface
- 14. removes a portion of a line at the point of intersection
- 15. allows you to go back if needed to change a previous action/command
- 16. creates a duplicate of the line/object selected
- 17. the measurement of angles- example 30,60,90
- 19. deletes the entire line when selected