Across
- 3. the valve that can be used for transport
- 6. gauze used to cover the insertion site if the tube dislodges
- 7. the patient will be identified prior to the procedure using their _____________.
- 8. if the bellows is expanded but less than the triangle mark, ___________ the wall suction to 80mmHg or more.
- 14. assessment; placement; tolerance of the procedure; presence/absence of bubbling; suction level; and the security of the dressing all need to be ________.
- 15. a _____________ needs to be completed prior to starting the procedure.
- 19. decreased breath sounds; asymmetrical chest rise; restlessness, irritability, or lethargy; increased respiratory rate; cyanosis; and abrupt change in respiratory status with increased work of breathing are all symptoms of _____________.
- 22. the chest tube needs to be connected to the chest drain __________ initiating suction.
- 23. provide an _____________ as ordered prior to the procedure.
- 24. the suction on the wall needs to be at _______ mmHg or higher
Down
- 1. the water and water port need to remain __________.
- 2. using a safety pin or kelly clamp and tab of tape, ___________ the tubing to the mattress
- 4. if this recurs after it had stopped, you need to check the drainage system and connections
- 5. the end of the drain tube that connects to the ________ needs to remain STERILE
- 9. device used to prevent air from being pulled into the pleural space if the drainage tube becomes disconnected from the chest tube
- 10. connect ___________ tubing to the same port that you placed the water into.
- 11. the patient will be identified prior to the procedure using their _____________.
- 12. location of the drainage system compared to their chest
- 13. supplies needed for chest tube placement can be found in the ____________.
- 16. connection sites along the chest tube and drainage tube should be __________
- 17. how many cms of water is required
- 18. inserting and ____________ the chest tube is performed by a provider.
- 20. the suction on the drainage system is pre-set to ________ cmH2o and should remain there unless otherwise ordered.
- 21. used to confirm proper placement
