Across
- 3. Type this to close an active Telnet session.
- 5. Command(s) used to determine a router's capacity to generate debug output. Show _________ cpu
- 7. This command is used to check LAN connectivity problems on a switch.
- 8. What metric does RIPv2 use to find the best path to a remote network?
- 9. Which IOS user exec command would you use if you suspect that a router on the route to an unreachable network is at fault?
Down
- 1. When a router looks up the destination in the routing table for every packet it is called _______ switching.
- 2. This command will verify your NTP client: show ntp _________.
- 4. What commands is used to determine the IP address of a directly connected device?
- 6. If you want to have more than one ________ session open at a time, you would press CTRL+SHIFT+6, then X
- 10. Advanced distance vector routing protocol.