CSM 066 General Cleaning Practices

2. Floors with poor ___ have a dull and uneven looking surface.
5. Applying floor finish to resilient tile in coats that are too thin causes ___.
7. Clean fabric, paper, or pleated lamp shades with a soft brush or ___.
9. The autoscrubber tank that holds the clean water and detergent is the ___ tank.
10. What kind of floor coating fills the small pores in a floor surface?
14. ___ is the curling of the edges of a board or tile.
16. Taking all the old wax or finish off a floor is called ___.
17. Putting a new coat of wax or finish on a floor is called ___.
18. You should never dry buff asphalt tile because it might contain ___.
20. The first step in cleaning a floor is removing ___ dirt.
21. The autoscrubber tank that holds the dirty water is the ___ tank.

1. Floors that let electricity pass through them are called ___.
2. When caring for ceramic tile flooring, only the ___ needs sealing.
3. The temperature at which a product will burn is its ___ point.
4. When you mop only the dirty parts of the floor, not the entire floor, you are ___ cleaning.
6. Apply all synthetic floor finishes in ___ coats.
7. There are two kinds of blinds: ___ and horizontal.
8. Then main function of a floor coating is to ___ a floor from wear.
10. A chemical that is used to remove old floor coatings is a ___.
11. How often should you remove dry dirt from wood flooring?
12. How many coats of finish should you apply near baseboards?
13. How often should elevators be cleaned?
15. In addition to being dusted daily, wooden furniture should be ___ periodically.
17. The appearance of gaps in wood flooring is called ___.
19. The thick mixture of stripper and old floor finish is called a ___.