Across
- 2. This is the path between two points, curved or straight.
- 3. This is a metal piece of equipment with two legs that is used to draw arcs and circles.
- 6. Softer pencil leads (like HB-6B) create _____ lines.
- 7. These are plastic "stencils" used to draw shapes quickly; you have two green ones in your drafting kit.
- 11. These are used to transfer dimensions from one drawing to another. It is a piece of equipment that resembles a compass, but instead of lead, has two metal points.
- 14. The most important reason for doing good freehand lettering is to make sure the information on the drawing can be easily __________.
- 16. The height of ___________ in mechanical lettering is 1/4".
- 17. Harder pencil leads (like 2H-9H) create ______ lines.
- 18. This is a single location in space.
- 19. This is considered the BEST medium for drafting.
- 20. This piece of equipment is used to draw irregular arcs and curves.
- 22. This piece of equipment is shaped like a "T" and is used to draw horizontal lines and support triangles for drawing vertical lines.
Down
- 1. The most important characteristic of freehand lettering is _________________.
- 4. ANSI says that the _________ between words should be the size of a capital O.
- 5. The most commonly used freehand style of lettering on engineering drawings is vertical Single Stroke _________ style.
- 8. This is a plane that is created from lines (flat or curved).
- 9. A good technique to sketch a straight line is to focus on the ________ of the line.
- 10. Fractions should be separated with this kind of line, not a slanted one.
- 12. The purpose of a sketch is to quickly explain an _____.
- 13. This is used to protect the drawing when you erase by protecting the lines that are to be kept while erasing the unwanted lines.
- 15. There are two of these for drawing vertical and angled lines; the 30-60-90 and the 45-45-90.
- 18. This piece of equipment is used to measure angles.
- 21. The ________ of letters in mechanical lettering is 1/8".