Across
- 3. What is the maximum voltage that can be outputted by the device using an output and ground pin
- 8. This symbol can be used to create a row vector between two given integers
- 10. This type of notebook Is preferred over a spiral notebook
- 12. Multisim allows the user to construct circuits, and then do what to them to collect data
- 15. You are able to choose from a wide variety of components from Multisim’s circuit what
- 16. On what panel of the scope should the power cable be plugged into to turn it on
- 17. Never remove or install components on a circuit that is this
- 20. What burst mode allows for a specified number of waveforms to be outputted
- 21. Presents the theoretical background for the lab procedure
- 23. All data, circuits, and calculations should be properly recorded in this
- 24. The front panel settings can be stored into one of how many internal memories
- 26. When the current level is smaller than the output setting, the supply operates in this voltage mode
- 28. You can erase waveform and setup info in the nonvolatile scope memory with this function
- 30. A sweep outputs a waveform with what signal and frequency
- 31. The Mod button on the panel allows you to create what type of waveform
- 33. The instrument can provide this number of standard waveforms
- 34. Keeping this type of notebook instead of a paper one can help protect against anything happening to it
- 36. Final course grades are 5% based on this
- 38. The section in the lab report where collected results are interpreted
- 39. This is the primary writing tool that should be used for writing in the lab notebook
- 41. The Analog Discovery can measure current by using this type of channel in the oscilloscope
- 42. You can perfectly simulate any circuit in Multisim because you can adjust the what of every component
- 43. You can use script such as for or while or if statements in MatLab to use this type of function
Down
- 1. This is the best color of ink to use in a notebook
- 2. Tracking parallel operation does what to the current capacity in the CH1/CH2 parallel tracking mode
- 3. The Analog Discovery Device has this number of ground pins
- 4. The different output modes can be selected by pressing this button on the panel
- 5. MatLab is able to take a list of data point and do this to them to visually represent the data
- 6. Multisim is a great way to simulate these to ensure they work properly before building them
- 7. The power supply has this many independent outputs
- 9. MatLab can be used to join arrays together in this process to make larger arrays
- 11. Submissions that are found to be this will not be accepted and will result in academic dishonesty
- 13. Its always important to provide this type of work environment when operating the oscilloscope
- 14. Multisim allows you to do what to simulated circuits to collect data from them
- 18. None of these will be accepted past their acceptance dates
- 19. These markers can be placed on screen to take manual measurements at specific points in collected data
- 22. The Analog Discovery has this many sets of scope probes
- 25. You can push bit rate and turn this to select from several predetermined bit rates
- 27. Office hours for Prof. Bowden are on this day of the week
- 29. Putting this at the bottom of every notebook page when it’s done is important to know the page is complete
- 32. The Analog Discovery has this number of waveform generator pins
- 33. MatLab comes equipped with a large number of these to perform processes, such as finding the largest input
- 35. A type of lab report that only documents results from the lab preformed
- 37. States the overview of the lab and what was done
- 40. The instrument can natively measure a sine or square or ramp or pulse and what other waveform