FANUC Safety

3. Only the person with the iPendant should be in the work _____.
5. The safety of the work area can be enhanced by the installation of some or all of the following device.
6. Use anti-tie-down logic to prevent the operator from bypassing ____ measures.
8. Mount an adequate number of ____ stop buttons or switches with in easy reach of the operator and at critical points inside and around the outside of the workcell.
10. The ____ of people is always of primary importance in any situation.
11. Never rely on software or firmware based controllers as the ___ safety element unless they comply with applicable current robot safety standards.

1. ______ pinch points
2. Never bypass, strap, or otherwise ___ a safety device, such as a limit switch, for any operational convenience.
4. Robots used in ____ (hazardous) locations must be certified for this use.
7. ______ wear watches, rings, neckties,scarves, or loose clothing that could get caught in moving machinery.
9. It is the responsibility of the owner, employer, or ___ to take all necessary steps to guarantee the safety of all personnel in the workplace.