FANUC Safety

2. Robots used in classified (hazardous) locations must be certified for this use.
3. Mount an adequate number of ____ stop buttons or switches with in easy reach of the operator and at critical points inside and around the outside of the workcell.
6. The safety of the work area can be enhanced by the installation of some or all of the following device.
9. Use anti-tie-down logic to prevent the operator from bypassing ____ measures.
10. The ____ of people is always of primary importance in any situation.
11. Never rely on software or firmware based controllers as the ___ safety element unless they comply with applicable current robot safety standards.

1. ______ wear watches, rings, nechties, scarves, or loose clothing that could get caught in moving machinery.
4. ______ pinch points
5. It is the responsibility of the owner, employer, or ___ to take all necessary steps to guarantee the safety of all personnel in the workplace.
7. Never bypass, strap, or otherwise ___ a safety device, such as a limit switch, for any operational convenience.
8. Only the person with the iPendant should be in the work _____.