Across
- 1. Always cut with a _____ blade.
- 5. Never stand ______ the blade.
- 6. A switch that should always be easy to reach on a table saw.
- 8. A waste piece that can get wedged between the blade and a certain fence mentioned earlier and produce kickback.
- 10. Always hold the stock firmly against the _____ gauge when crosscutting.
- 12. Prevents the stock from pinching the blade as it's being cut.
- 13. A table saw with a fixed, horizontal table and a blade that can be raised, lowered, and angled.
- 14. The most common table saw on a job site.
- 15. The blade _____ should be kept in place whenever possible.
Down
- 2. The ___ fence is used for all ripping operations.
- 3. Contractor table saws are sometimes called this.
- 4. Keep the saw _________ to prevent accidental startup.
- 7. The aforementioned gauge above slides back in forth in one of two grooves, those grooves are ________ to each other.
- 9. A piece of stock with a series of long saw cuts on one end.
- 11. A ______ plate partially covers an opening in the center of the table to stop small pieces of wood from being wedged against the blade.