Hermpac Machines

2. / at the back of shed 2/3 this is the final stop for the seen face of HP808
11. / in shed 7 used to machine holes into power pole cross arms
12. / in the entrance of the machine sheds this wraps packets smaller than 300mm x 300mm in cling plastic - often hand parcels
13. / in shed 7 used to cut weatherboard feedstock very efficiently turning 64mm into 3 boards
15. / in shed 2 mostly used to profile weatherboards and some D4S stock
16. / in shed 7 used to dock timber to precise lengths and for grading knots/lengths
18. / in shed 3 manufactures decking/large D4S and blanks numerous timbers

1. / in shed 2 mostly profiles mouldings panelling and large volumes of small D4S
3. / in shed 2 used to continue the T&G around the ends of panelling/flooring
4. / in shed 2 these two both cut timber to size giving a slightly rough finish
5. / in shed 2 this is used to recover/resize rejected stock in small volumes
6. / moves between sheds 2/3 it’s used to resize timber and dress the occasional small order
7. / in the entrance to the machine sheds this is named after its colour and is used to square packets up before strapping
8. / newest Hermpac machine – we will find out what this does today
9. jon / outside shed 7 this gets its nickname from an ex-employee who used to fillet packet loads of timber arguably faster than this machine
10. / in shed 7 this is the title given to the three machines that pre coat our products (flood, spray and flooring machines)
14. / runs throughout the whole yard this machine is more of a tool with a shorter temper than his iconic shorts
17. / in shed 2 looks like it is on an angle and is used for smaller D4S orders