Intro to Battery/Starting/Charging Systems Diagnostic Tester

Edit Answers
12345678910111213141516171819202122
Across
  1. 1. CCA = _____ Cranking Amps [slide #39]
  2. 5. Failed batteries display ____ battery after the test [slide #46]
  3. 6. Type of voltage signal generated by the tester [slide #7-2]
  4. 8. Black clamp goes on the ____ battery terminal [slide #36-3]
  5. 11. Number of systems tested when "System Test" mode is activated [slide #22]
  6. 12. The tester requires __ AA batteries [slide #68-2]
  7. 13. CP stands for Conductance P_____ [slide #16-2]
  8. 14. Ignition on/doors ajar can cause "System ___ Detected" message on tester [#40-2]
  9. 15. "____ Capacity" how long a battery can be used before being discharged [slide #16-4]
  10. 16. Weak batteries or recently charged the tester may display "____ Battery" [slide #40-3]
  11. 17. CA = _______ Amps [slide #39]
  12. 19. If you connect the clamps wrong the tester displays "Clamps ____" [slide #36-3]
  13. 21. Low battery might require a "___ Scan Test" to super analyze the battery [#40-4]
  14. 22. Good batteries display ____ battery after the test [slide #46]
Down
  1. 1. If the clamps are poorly connect the tester displays "Check ____" [slide #36-4]
  2. 2. Which system test can be run individually? [slide #22]
  3. 3. Upper left corner of screen shows the ______ [slide #21-2]
  4. 4. JIS = _______ Industrial Standard [slide #39]
  5. 7. Alternator is part of this vehicle system
  6. 9. Boats require a ____ battery [slide #38]
  7. 10. The tester has an _____ printer [slide #68]
  8. 13. Red clamp goes on the ____ battery terminal [slide #36-3]
  9. 18. Minimum amount of time you should flush your eyes of battery acid
  10. 20. Type of battery that requires special adapters for testing [slide #35-3]