Across
- 2. Color coded markers are Acceptable if they read ________ from the connector.
- 3. For multiple wires crimped into the same terminal, _____ tests shall [D1D2D3] be performed on the smallest wire in the crimp.
- 7. Strands that can be damaged for a Class 3 wire with 18 strands that is to be tinned.
- 8. Full-_________ tools shall[N1N2D3] be used for Class 3 crimping.
- 9. When "N2" is found in brackets next to a "shall" statement, it indicates "No ____________ established for Class 2.
- 10. When the word "should" is used, it means that it is a ____________.
- 13. With over-molding, _________ raised greater than 0.75mm that does not interfere with mechanical or electrical function is a Process Indicator for Class 1,2,3.
Down
- 1. Conductors shall not [D1D2D3] be ___________ together before insertion into the terminal.
- 4. A clove hitch knot shall [D1D2D3] be secured with a __________ knot.
- 5. What is the smallest tolerance measurement in Table 11-1?
- 6. For a machine contact crimp to be Acceptable, the wire conductor must be visible in the inspection _________.
- 7. With Lap Solders, the wire ends shall[D1D2D3] be stripped so that the wire overlaps a minimum of _______ conductor diameters.
- 8. For Class 3 hard face connectors, it is a defect if there is any evidence of chipping or cracks in any contact ________.
- 11. For RJ Type modular connectors, the product if Defect if all wire __________ are not visible through the face of the connector.
- 12. Any violation of minimum electrical clearance is considered a ________.