Across
- 2. Method using average and alternating stress components
- 7. Life of a component under infinite load cycles
- 8. Component used to connect two shafts rigidly
- 10. Safety factor is also known as factor of ____
- 11. Type of key widely used for shafts due to ease of manufacturing
- 12. Type of stress when two equal and opposite forces act along same line
- 15. Torque transmitting element fitted in shaft keyway
- 16. Factor used to account for notch effect in fatigue
- 18. Stress ratio R = σmin / σmax
- 19. Type of joint where plates are fastened by rivets
Down
- 1. Preferred method of fastening for high rigidity and permanent joints
- 3. Type of failure due to repeated loading below ultimate stress
- 4. Coupling used to connect shafts with slight misalignment
- 5. A short cylindrical pin used in hinged joints like levers
- 6. Diagram representing alternating stress vs mean stress
- 9. Ratio of load to cross-sectional area
- 10. Diagram showing safe and unsafe regions for varying loads
- 13. Power transmitting element subject to torsion
- 14. Curve representing failure criterion between ultimate and yield strength
- 17. Gear type where teeth are cut parallel to axis