NC3 Pneumatics

1. Measures pressure below the atmospheric pressure
2. A ball valve used to block or allow full flow rate
3. The suction gripper can be used in conjunction with the vacuum generator to create suction.
9. make use of compressed air to reduce or eliminate friction between the bearing and a work surface
10. Start-up valve with filter control valve
11. Flowmeters are used to measure flow rate in a fluid circuit.
14. reduce the noise created by the expansion of air exhausting a component.
15. 3/2-way valves with Pushbutton Actuator with Normally Open NO 3/2-way valves with Pushbutton Actuator Normally Closed NC
16. Pneumatically actuated at both ends. valve has five ports and controls flow direction
18. Cylinder that generates a force in two directions (extension and retraction)
19. When conected to the start up valve, the manifold supplies compressed air to eight individual outlets
20. The long resistor is used to generate a pressure drop in a fluid circuit

1. The vacuum generator creates pressure below atmospheric level (negative pressure).
4. Show pressure above atmospheric pressure
5. A cylinder that generates a force only in one direction (extension)
6. Puts a force on the cylinder
7. T-connectors are used to interconnect or split compressed air lines.
8. This component controls flow rate in one flow direction
12. Reservoirs are used in a pneumatic system to store compressed air
13. Pneumatic motors are actuators that convert fluid energy into rotational motion
17. completely block the exhaust of air.