OR Workshop

2. Blood must be hung within ______ minutes of when it left the Blood Bank
7. The procedure to add to your CS case when a tubal is preformed id called Laparotomy _____-ectomy
8. T/F: When hanging a subsequent unit of blood, you can use the same Y-tubing and saline
15. The count should be led by the _______ using the inventory sheet.
16. Don’t forget to put a patient ____ on all copies of the blood transfusion record, including both carbon copies
17. All _____ need to be loaded in the counter bags at the end of the case so the provider can visualize and account for each one.
18. Number of sponges that should be added to the table at a time ____
19. When an item cannot be found and an XRAY in needed during the OR procedure
22. Blood products that are part of the MTP that do not need to be cooled are ______ and cryo.

1. Products in the MTP cooler are good for __________.
3. After initial infusion, you can ______ the rate of the blood infusion to go in more quickly-within 2-4 hours.
4. The ____ machine can be used for a tubal ligations if a provider prefers
5. Patient consent is ____ needed during STAT situations
6. If the patient has a _______ increase in their temperature, stop the infusion immediately.
9. Fill out the counting whiteboard _____ the initial count.
10. If administering more than two units of blood, you must use a blood _______
11. When an item cannot be found during a count but is later found
12. When starting a blood transfusion, begin the pump at 50mL/hr for _____ minutes
13. The _____ on the HemoTemp2 indicator proves the blood is still suitable for transfusion
14. T/F: Uncross matched O-neg blood can be used for fetal and maternal use.
20. When counting the instruments, always count the ____ of the instruments, not the handles
21. When doing counts, make sure all the providers stop for the ______ to make sure all laps are accounted for