OSPF Terms

1. Command for the re-assigning of the router id change to take effect.
4. Command to verify that each router lists the other routers in the network as neighbors.
5. OSPF Hello and Dead intervals must ?, or a neighbor adjacency will not occur.
7. Disable the interface as passive.
8. Whose primary function is the fast and efficient movement of IP packets. Interconnects with other OSPF area types. Called OSPF area 0
10. To enable OSPF
11. Only send their LSAs to the DR and BDR using the multicast address 224.0.0.6.
14. (ASBR) An OSPF router that performs route injection (redistribution) from another route source (RIP, EIGRP, IS-IS, BGP, another OSPF process, etc.).
15. When troubleshooting OSPF neighbors, be aware that the ? or 2WAY states are normal.
16. OSPF uses the bandwidth setting to calculate the cost for a link by default. However, you can override this calculation by manually setting the cost of a link using the ? command.

2. Instead of setting the router ID on all routers, it is better to control the election by setting interface priorities
3. Command to set the default for all OSPF interfaces as passive.
6. At least one OSPF interface must belong to area 0 and at least one OSPF interface must belong to a non-backbone (area 0) area.
9. Command to verify that a route is being advertised.
12. Used to uniquely identify the router in the OSPF routing domain
13. DR and BDR elections only necessary on what type of networks?