Across
- 7. This category of supports is primarily for tubing and should only be used for piping as a last resort
- 8. These physical interferences must be cleared before an isometric can be issued
- 9. Where model review comments are logged
- 10. What must you do to a PID prior to submitting an isometric to checking
- 11. In addition to Coreworx, this is one of the primary hubs of project documents
- 13. Software used to identify errors with isometrics
- 15. These interfaces at sheet breaks should be checked in the model and on the PID
- 16. Visual software used in model reviews and discipline coordination
Down
- 1. Located a low points, these allow liquids to be removed from a system
- 2. What should be submitted for C1 and C2 lines prior to sending an ISO to checking
- 3. A snapshot of this must be submitted with your isometric package for the first submission of a given revision
- 4. This document must be filled out for the initial submission of an isometric, but doesn't need to be resubmitted when submitting an ISO of the same revision from back draft
- 5. What aspect of insulation should be verified based on line list temperature data
- 6. A fresh version of this type of isometric must be submitted in addition to your fabrication ISO every time you advance an isometric package to checking
- 12. Located at high points, these allow gasses to be removed from a system
- 14. Software used to track design effort