Safety Crossword

3. You must have this before you can use any machine in the lab.
6. The smallest pice that can be sanded on the disc sander is a _______ inch square.
8. The part of the drill press which holds the drill bit.
11. The type of hammer used to remove nails.
12. Sand on the __________ motion side of the disc sander
16. Used to protect your eyes while using tools and machines.
19. While cutting, shaping, drilling, or forming any material, you should use either a clamp or a _______ (when able).
20. Used to cut straight and semi curved lines.
21. The part of the bandsaw where the materials rests.
22. Shoes with ________ toes should be worn while working in the lab.
24. Power must be shut off and the chuck must come to a stop before _______ the machine.

1. You should never carry a backsaw by its ________.
2. The greatest hazards posed by hand tools result from ________.
3. Require a non-human power source to function properly.
4. What type of surface should you never strike with a metal hammer.
5. Only _______ student may use each sander at a time.
7. The closest distance (in inches) that your hands may ever be to any moving part of the drill press.
9. A ________ ______ is used to tighten the chuck around a drill bit.
10. When using the drill press you should feed the bit __________ into the work piece.
13. Hands should never be _________ with the saw line when operating the bandsaw.
14. This should always be used to clear material and scrap pieces away from the bandsaw blade.
15. Have no power source, other than the physical force applied by the user.
16. The area of the shop floor where the machine operator should stand.
17. The upper blade ________ should be set to 1/4" above the work piece prior to cutting.
18. The "Emergency Buttons around the room are to be used whenever the ________ in the room needs shut off.
23. If a bandsaw blade breaks while you are using the machine you should always ________ me (the teacher)