Across
- 1. The safety concern with the safety cutter is that it gets ___
- 4. do not _____ on a file
- 8. Hold onto the plastic very ______
- 9. keep your fingers out of the ____ of the cutter
- 10. your work area clear of
- 13. The safety concern with the foam cutter is that it gets ____!
- 14. hold onto the ______ _____ securely to add or remove bits on the driver
- 15. .use the ______ and ______ switch to add or remove bits
- 18. ____ equipment before servicing
- 19. set the dial to _
Down
- 1. Adjust the deck _____ of the press appropriate to the material
- 2. Keep a close eye on the plastic as it ____, otherwise it will melt onto the burner.
- 3. in doubt ask your ______
- 5. The injection molder will get to an extremely ____ temperature.
- 6. ._______ a running tool unattended
- 7. keep guards in _____
- 11. operator only the ______ should be turning the saw on/off
- 12. disconnect the tool by pulling on the ____ not the cord
- 16. The foam cutter is used in the _______ expedition
- 17. Do not put fingers near the _____ when tightening a screw