SMAW/GMAW

2. What PSI do we run the regulator for shielding gas?
4. How man amp breaker is the power supply for the welders?
7. MIG welding uses a ____ electrode.
12. The width of your weld should be ___ the size of your electrode. (Stick Welding)
13. What does the E in ER-70-6 stand for in MIG Wire?
15. This tool removes the slag off of your weld.
20. What does GMAW stand for?
21. This is the most common part problem with MIG welding.
22. What does SMAW stand for?

1. What size wire do we use in MIG welding?
3. Current When the current flows in one direction.
5. What does the 1 in 6013 represent?
6. This pressure is higher on the regulator and lets you know how much gas is in the tank.(larger numbers)
8. What holds the electrode in stick welding?
9. This is used to clean the metal and the area where the weld was made.
10. This is how we adjust the heat on MIG welding.
11. This is why MIG welding is difficult to use outside.
14. This pressure is adjusted by you on the regulator. (has smaller numbers)
16. This device connects the ground clamp to the welder.
17. This is used to connect the ground lead to the work piece.
18. What does 60 in 6010 represent?
19. Current When electricity flows one direction then reverses.