Surface and Mine Issues

3. You should never connect or disconnect an electric power cable when under a _____.
5. What must all individuals wear when on top of trucks, barges, working over six feet with a risk of falling, and on a bench top within 6 ft of the edge or past the last line of drilled holes?
8. What is the main hazard associated with methane?
9. What is not allowed in the mine and only in designated areas on the surface?
12. What type of permits will be obtained and procedures strictly followed, where required?
13. Always stand to the _____ of electrical switches when energizing or de-energizing
14. All hazards such as manholes, trenches, excavations, or drop-off shall be properly __________.
15. Is methane found high near the roof or low near the floor?
17. Cap lamps must be carried and __________ by all persons underground except when in an office building.
18. What kind of hazard does laying a chord on the floor without being taped or properly covered create?
19. What must be done with a damaged tow strap or an electrical chord with a missing ground prong?
21. During transportation, detonators shall be _____ from explosives or blasting agents.
23. Never make a process, equipment, or procedural change without the required _______.

1. Reporting-Immediately report all injuries, illnesses, and property _______.
2. When utilizing any tool or equipment with an electrical chord, a ______ inspection must be made.
4. Where hazards exist, gloves and loose fitting clothing will not be worn while working around rotating ______ of machinery.
5. This is everyone's responsibility!
6. What type of vehicle should always yield the right-of-way?
7. Explosive magazines shall be _________ when unattended.
10. What are faces and muck piles examined for after each blasting operation?
11. A compressed gas cylinder should always be in what position?
16. The area of an serious accident, which may result in the investigation by MSHA or company personnel will be _____ and the site will not be disturbed.
20. What is the purpose of roof bolting?
21. A fire extinguisher on a piece of equipment should be checked each ______ it is used.
22. What can never be used to repair an extension cord?