Table Saw Safety

1. Never stand in the __ zone and make sure no bystanders are behind the saw before turning it on.
4. Never __ a board into the blade and do not back a board out of a cut.
6. Never remove __ while the saw is running or while the blade is still moving.
7. The __ is always used to make rip cuts.The __should never be higher than ¼ of an inch above the workpiece.
8. All boards must have a __ edge to be cut on the table saw. This edge must go against the fence.
9. The miter __ is always used to make cross cuts.
12. Do not use the __ gauge and the fence at the same time.
14. The guard and ___ knife may never be removed when operating the table saw.
15. A ___ must be used for ripping boards less than 4 inches wide.
16. Boards less than 12 inches long and/or 1 1/2 inches wide may not be __ on the table saw.
17. Always make __ when the power is off and the saw is unplugged.
18. Never __ cut on the table saw.

2. Ask your __ for help when sawing boards longer than 2 feet.
3. The __ should never be higher than ¼ of an inch above the workpiece.
5. Only the ___ may turn on the table saw.
8. Ask your instructor if you are unsure a __ procedure is safe.
10. Do not cut wet or __ boards on the table saw.
11. ___ must be kept out of the guard area.
13. Always ask your instructor for __ to use the table saw before using it. Be prepared to show and/or explain what you will be cutting.
16. Keep the saw __ and free of sawdust and scrap wood.