tools

Edit Answers
12345678910111213141516171819202122232425262728293031
Across
  1. 4. Used to replace piston rings without damaging or breaking themGFCI-Overcurrent Protection Device (Ground Fault Circuit Interrupter) -protects us from receiving electric shocks from faults in the electrical devices we use in our home.
  2. 9. A precision instrument for measuring the inside dimension of an object, such as the diameter of a hole or the width of a groove.
  3. 11. This tool is designed to reach into the small recesses where valve springs and retaining washers are located.
  4. 15. Tools used to keep the flywheel from spinning and Pulling it from the engineThe puller bolts into the flywheel and tighten with the socket.
  5. 17. too hot
  6. 18. Rotates to push piston up in cylinder, converts the reciprocating motion to rotary motion used by the application
  7. 20. regulates what enters and exits the internal combustion engine.
  8. 22. Tool most commonly used to properly gap a spark plugSpark Tester- Used to see if the spark plug is in working order or if it needs to be replaced Spark Tester- Used to see if the spark plug is in working order or if it needs to be replaced
  9. 23. excessive speed or irregularity on WFS
  10. 24. A precision instrument that can be used to measure internal and external distances extremely accurately.Telescoping Gauge- A measuring tool with spring-loaded plunges used together with a micrometer to measure the inside of holes or bores
  11. 25. used to fasten and remove philips head screws
  12. 27. Tool used to set and adjust tightness of nuts and bolts to a desired value. Used to prevent under or over tightening
  13. 29. an automatically operated electrical switch designed to protect an electrical circuit from damage caused by excess current from an overload or short circuit
  14. 30. used to connect two or more wires together
  15. 31. Used to see if the spark plug is in working order or if it needs to be replaced
Down
  1. 1. attaches to connecting rod to secure it around the crankshaft
  2. 2. Tool used to measure widths, Most commonly used to check clearances between two parts
  3. 3. An interruption in the typical structure of a material. Most times is a defect, but not always
  4. 5. used to reach nuts and bolts boxed ended wrenches can't
  5. 6. Used to compress rings into ring guides to replace piston into the cylinder
  6. 7. Encloses the wiring connections and protects them from damage. mounts the electrical device and secures the electrical cable(s) serving the device. Prevents accidental contact with live wires and terminals
  7. 8. cylinder fitting closely within a tube in which it moves up and down against a gas, used in an internal combustion engine to derive motion
  8. 10. A measuring tool with spring-loaded plunges used together with a micrometer to measure the inside of holes or bores
  9. 12. connects the crankshaft to the piston and converts reciprocating (up and down) motion into rotary (circular)
  10. 13. typically caused by travel speed being too fast or too high amperage
  11. 14. (Ground Fault Circuit Interrupter) -protects us from receiving electric shocks from faults in the electrical devices we use in our home.
  12. 16. used to fasten and remove standard screws
  13. 19. responsible for valve timing
  14. 21. used to remove insulation from wires
  15. 26. can be caused by contaminated surface, improper gas shield so contaminants get in from environment
  16. 28. A fuse is a small, thin conductor designed to melt and separate into two pieces for the purpose of breaking a circuit in the event of excessive current.