Across
- 3. Joint with a projecting member fitting into a matching cavity
- 11. Joint with interlocking wedge-shaped pins and tails
- 12. Simple joint where one piece of wood is placed directly against another
- 14. Joint formed by removing half the thickness of each intersecting piece
- 15. Joint that uses cylindrical wooden pins in matching holes
- 17. Joint that uses matching rectangular fingers that interlock
- 18. Oval-shaped wooden insert used for alignment
- 20. Joint using an angled hole and screw for fastening
- 22. Joint commonly made with two matching 45-degree cuts
- 24. L-shaped recess cut along the edge or end of a board
- 25. Joint where a projecting tongue fits into a matching groove
Down
- 1. Strong decorative joint using partial dovetail geometry
- 2. Projecting part that fits into a mortise
- 4. Joint created by overlapping portions of two wood members
- 5. Joint with an open slot that receives a matching tongue
- 6. Joint using a compressed oval-shaped wooden insert
- 7. Force that attempts to pull connected members apart
- 8. Cylindrical wooden pin used to strengthen a connection
- 9. Groove cut across the grain to receive another board
- 10. Joint used to connect pieces end-to-end to create a longer member
- 13. Groove commonly used to support shelves in cabinets
- 16. Force that twists a connection
- 19. Force that causes connected pieces to slide past one another
- 21. Cavity designed to receive a projecting tenon
- 23. Joint with an L-shaped recess along the edge of a board