Across
- 5. The finished surface of a weld
- 6. A right-angle triangle attached to either side of the reference indicates a
- 7. A type of weld joint where two parallel members overlap each other
- 9. The field weld symbol is a supplementary symbol is indicated by a
- 11. The height of a weld above the base metal in a groove weld
- 12. The primary element of any welding symbol
- 14. To perform a 2G weld the plates are positioned vertically and the weld is made in the
- 15. The sloped surfaces on which weld metal is applied in a V-groove weld
- 18. The graphic representation of a weld to be performed is called a
- 19. The weld-all-around symbol is indicated by a _________ at the junction of the reference line and arrow
- 21. Information appearing above the reference line refers to the
Down
- 1. Information that appears to the right of the weld symbol refers to the .
- 2. Plug and slot welds are commonly used on this weld joint
- 3. A weld applied to the other side of a groove weld after the front side has been completed
- 4. A welding process that is semi-automatic and uses a continuous feed electrode wire
- 8. Not considered a type of weld joint
- 10. A weld applied before to the other side of a weld joint before the groove weld is started
- 13. The junction between the surface of a weld and the base metal
- 16. Information that appears below the reference line refers to the
- 17. A weld produced by filling an elongated hole in an overlapping member, and attaching it to the member beneath is called a
- 18. Information that appears to the left of a weld symbol refers to the
- 20. The center-to-center distance of an intermittent fillet weld