Across
- 3. A power tool used to cut decorative edges or grooves.
- 6. A sander where you must only sand on the downward-moving side.
- 8. The direction of the fibers in a piece of wood.
- 13. A machine that spins wood to create bowls or table legs.
- 14. A tool used for very precise measurements of thickness.
- 16. A wooden peg used to reinforce a joint.
- 17. A machine used to make the edge of a board perfectly straight.
- 20. Wood made of thin layers glued together.
- 23. A wooden or rubber hammer used to strike a chisel.
- 24. A tool used to check if a corner is exactly 90 degrees.
- 25. A clear finwo pieceish applied to protect the wood.
- 26. Always remove the ______ from the chuck after tightening a bit.
- 28. Use a ______ stick to keep fingers away from moving blades.
- 30. Use a ______ gage when cross-cutting a board on the band saw.
- 32. A heavy tool on a workbench used to hold a project still.
- 34. The part of the drill press that holds the bit.
- 35. A sharp metal tool used for carving or paring wood.
- 37. The oscillating ______ sander is used for interior arcs.
- 38. A very coarse file used for rough shaping of wood.
Down
- 1. The tiny particles of wood created by cutting or sanding.
- 2. A hand tool used to shave thin layers off a board.
- 4. The most common type of bit used for small holes.
- 5. A hard, dark circle where a branch once grew.
- 7. These glasses must be worn at all times in the shop.
- 9. A scratch ______ is used to pre-mark a hole for drilling.
- 10. A flat bit used to drill large through-holes.
- 11. The number that indicates how coarse or fine sandpaper is.
- 12. A sanding device that uses a continuous loop of sandpaper.
- 15. Band saw teeth must always point in this direction.
- 18. Cuts made to prevent the band saw blade from binding on curves.
- 19. A bit used to drill flat-bottom holes.
- 21. Used on the band saw for ripping or resawing a board.
- 22. Used to secure a work piece to the drill press table.
- 27. When the wood is thrown back at the operator.
- 29. Used to change the color of the wood.
- 31. On a band saw, use this only in emergencies.
- 33. A tool used to see if a surface is perfectly horizontal.
- 36. The general name for the cutting tool used in a drill.