Across
- 2. what stroke to sand on disk sander
- 4. long end of work should be placed on this side of drill press
- 5. never look _________ the planer while it is running
- 8. minimum length in inches for jointer/planer
- 9. should be clear before using the router
- 10. avoid jointing edges that contain these
- 11. how the hand router should be held
- 15. what should you do with router when finished (wait, ____ _____, pointed away)
- 16. chuck key should be __________ from chuck and table before drilling
- 19. cut to prevent bending or breaking of band saw blade
- 21. never apply direct _________ over jointer blades
- 23. never use this and the fence together on table saw
- 24. use clamp on drill press if this size or smaller
- 25. do this frequently on drill press to insure bit can cut properly
- 27. always keep these 4 inches from blades/bits/abrasives
Down
- 1. amount that should be removed on planer
- 3. number of pieces should be cut on miter/up cut saw at a time
- 5. never let someone stand to the right or end of this when using jointer
- 6. where to stand when using table saw
- 7. direction boards should be run in planer
- 12. _____% of the time look at the fence and 25% of time look at blade when cutting on table saw
- 13. what throat size to use on spindle sander
- 14. always make sure boards are tight against this when cutting on miter/up cut
- 17. used when cutting or drilling round stock
- 18. where should you stand when using the planer
- 20. direction should you sand with edge/spindle sander and router
- 22. never ____ board back through on table saw, always push
- 26. should be placed 1/4" above material on band saw/scroll saw