Across
- 2. What is the number one priority in the shop?
- 5. Sander What machine is the best choice for removing small amounts of material from the face of a board?
- 7. What is the minimum material length when ripping on the table saw?
- 9. The edge of your board must be tight against the _____ when performing crosscutting operations on the miter saw.
- 10. Always use a ______ when crosscutting more than one board to the same length.
- 12. Which machine would be the choice to flatten, straighten and square the edge of a board.
- 15. Saw You should always use push pads when creating dadoes or rabbets on a _____ ___ .
- 16. What machine is the best choice for removing large amounts of material from the face of a board?
- 19. Jointed Edge Always place the ______ ______ ______ of your board against the fence when ripping on the table saw.
Down
- 1. When ripping on the table saw, if the fence is set to _______ inches or closer to the fence, you must use a puch stick.
- 3. Saw Which machine is the best choice to rip material to final exact width?
- 4. Inch How far above your material should the foot of the bandsaw be set?
- 6. Saw Which machine is the best choice to crosscut material to final length?
- 8. What is the process of joining two or more boards together to create a longer or thicker board?
- 11. Saw What machine is the best choice to rough cut sheet goods or rough lumber?
- 13. How many cuts does it take to cut a board to length on the miter saw?
- 14. the table saw
- 17. Grain You should never joint the _____ _____ of a board.
- 18. Height Name one thing that must be checked prior to using the table saw.